Common metal roof problems
- Screw washers that have dried out and cracked
- Screws backed out by heat and cold cycles
- Open side laps and end laps
- Surface rust where the finish has worn
- Faded, chalky paint
Our coating process
- Clean and remove loose rust and paint
- Prime rusted areas
- Tighten or replace fasteners
- Seal seams, laps and fasteners
- Apply a reflective elastomeric topcoat
Snow and metal roofs
Snow slides off metal, sometimes all at once. Coatings don't change that much, but check that snow guards, where installed, are secure and sealed.
Coat or replace?
If panels are rusted through or bent, they should be replaced. For a full new metal roof, see metal roofing.
Call (505) 257-2289 for a look at your metal roof.
Common questions
Do you coat standing-seam roofs?
Rarely needed. Concealed-fastener roofs usually need only spot repairs.
Can you coat a shed or garage?
Yes. Outbuildings are often a quick, affordable job.